Rail length and finish
The Classic Rail System, also called J-rail, is available in 3 finishes: white, white primer and aluminium. The rail can be cut to size with a metal saw if needed. White primer rails can be painted over e.g. in a colour of your wall or left as it is. This rail is open type which means that the wires are hung on the rail.
Please note, you will also need an install kit. It consists of 6 plugs and screws, which you need for fitting it on your wall. The only part of installation where a bit of DIY is required is drilling 6 holes per 2m rail. About every 40cm. Put the plugs in, screw the rail on. That’s it.
Classic Rails can be installed next to each other. No connectors are required. You can have them fitted at any height on a wall all the way to the ceiling. They’re very easy to use. If you need to hang heavier artwork than 20kg, please check Classic Rail Plus (max. 100kg).
- length: 2.0m
- dimensions: 20.0mm x 6.7mm
- finish: white, white primer, aluminium
- max. load: 20kg/m
- warranty: 10 years
Perlon Wire with Loop
If you prefer to use an S Hook with your Classic Rail system, you will need a Perlon Wire with Loop to hang your framed art and pictures. Simply put a hook on rail, loop a wire on it. All done and ready to use. This wire is also available in Steel.
Lengths: 1m, 1.5m, 2m, 2.5m, 3m
Perlon Slider Wire
This 2mm perlon wire has a hexagon hanger on top if it. To use it with a Classic Rail, you need to thread it through a Cylinder Hook (below). Then you can hang it on the rail anywhere you want to create a perfect display wall.
Lengths: 1m, 1.5m, 2m, 2.5m, 3m
Alternatively you may opt in to use rods instead of wires. We offer this rod in white or steel finish. It is round shaped. To hang frames with rods, you will need Sliding Springs. This rod is 2m long. If you require different lengths, do contact us.
The thinner rod, which has 2mm diameter, can be used with Mcro Grip, Ratchet or Loqqer Hooks. You can place the hooks anywhere along the rod. This rod has a Steel finish. It comes in 2m lengths. If you require 1m length, please contact us.
Micro Grip Hook
An extremely easy to adjust self-locking hook with maximum load capacity of 20kg. Just squeeze it with your fingers to move it along the wire. On release it will lock itself securely in place.
A self-locking hook with a security mechanism for frames up to 15kg. Adjusting it is easy. Just press the top of the hook. The spring mechanism protects your frames from unintentional unhooking.
A screw-locking hook for lighter frames of maximum load capacity of 4kg. It is very easy to use. Loosen the screw to move it along the wire and then tighten the screw to secure it firmly in place.
This hook is hape of letter S. The top of this hook finishes in white goes on the rail while the bottom is for hanging looped wires. You can move it along the rail and place it wherever you want.
This hook is to be used with Perlon Slider Wire, which has hexagon hanger on top of it. Just thread the wire through it and hang the hook on the rail. That’s it. We offer this hook in white or steel finish.
To be used with 3mm rods. Very easy to use. Just squeeze it up with your fingers to moveit up or down along the rod. On release, they will stay in place. They can hold up to 20kg.